Wiring loom basic set MP25

Basic wiring loom for the MP25 ECU.
The basic wiring includes all cables in reliable sleeves needed to make a complete wiring harness. On one side the pins are already connected at the ends of each wire to ensure easy installation.
All that's left to do is install the connectors, connect them to each component, and route the wires where you want the ECU installed. Here you cut all wires to the correct length and fitted the main connector. The main connector is not included in this set but can be purchased seperately.

This basic wiring loom includes:
- Lambda 1
- Injection (type depends on your engine)
- Ignition (type depends on your engine)
- Water temperature
- Air temperature
- TPS (throttle position sensor)
- Map (manifold/air pressure)
- Crank sensor
- Extra wireset MP25

Choose in the Motorconfiguration section the amount of cylinders and whether you look for direct fire or staged injections.